After a couple months off, I'm back to trying to figure out how to install a complete new drop curtain. The car came to me without anything back there but a glued in shelf. So, I'm starting from scratch.
I've purchased the "Garnish Kit Covering" from CASCO and it is pictured below.
So, my question is where are there instructions as to how to install the entire assembly?
Is there a publication that I can purchase that will guide me through this?
Any help would be appreciated.
'56 TB Garnish Kit Covering
Moderator: Joe Johnston
Re: '56 TB Garnish Kit Covering
Did you ask CASCO had any instructions on how to install the Garnish kit Before you purchased it ?
1956 Thunderbird Sage Green
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309
Re: '56 TB Garnish Kit Covering
I did not.
I'm asking the forum if there is a source for instructions on how to install it.
Do you have one?
I'm asking the forum if there is a source for instructions on how to install it.
Do you have one?
Re: '56 TB Garnish Kit Covering
I haven't looked but does the trim & sealer manual address this?
VTCI # 13223
Re: '56 TB Garnish Kit Covering
I installed the drop curtain in my 56. It's kind of late to do a write up but I can do it tomorrow and send it to you email. Just message me your email and I will send it to you. I had the garnish molding done by an upholsterer so cannot help you there.
1956 Fiesta Red 312
1954 Ford Victoria 312
1948 Ford Convertible Street Rod 302
1954 Ford Victoria 312
1948 Ford Convertible Street Rod 302