I have a 1963 hard top that I added aftermarket a/c. The installer changed the engine cooling fan to an original 7 blade w/clutch. I added a fan shroud in an attempt to keep the engine cool but still have problems when idling in traffic in that the temperature slowly climbs until I can pick up speed or it overheats. I've decided to go with a flex fan with no clutch which should pull more air when at idle. I need to know what diameter fan was original so I can purchase a fan that should fit the shroud i have. Does someone happen to know?
Thank you for your help!
Fan diameter
Moderator: ABQTBird
Re: Fan diameter
With summer temps this has become a "Hot" topic....Sorry, could not help myself.
http://vintagethunderbirdclub.net/phpBB ... 9e45ae561f
http://vintagethunderbirdclub.net/phpBB ... 9e45ae561f
There is an extensive string of replies to this item over in the 61-63 Modified section, I believe your fan issue is addressed there? Or may be?
http://vintagethunderbirdclub.net/phpBB ... 9e45ae561f
http://vintagethunderbirdclub.net/phpBB ... 9e45ae561f
There is an extensive string of replies to this item over in the 61-63 Modified section, I believe your fan issue is addressed there? Or may be?
Re: Fan diameter
I have seen Flex fans as large as 18 inches- look into that- not sure you have the room.
Re: Fan diameter
You could place the fan in front of the radiator there is plenty of room there....
1956 Thunderbird Sage Green
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309