67 starts then dies as I let go of key
67 starts then dies as I let go of key
I got a 1967 that I been working on, my problem is it starts up then dies as soon as I let go of the key, thought it was bad ignition bypassed it with a remote start switch thing and it didn’t help, after further research it could be a ballast resistor? Any one had this problem before?
- 55Greg&Amy
- Posts: 1197
- Joined: Sun Nov 09, 2008 8:43 am
Re: 67 starts then dies as I let go of key
That is the exact symptom of a bad ballast resistor.
Greg Minnich
Kendallville, IN
Kendallville, IN
Re: 67 starts then dies as I let go of key
Would you happen to know where it’s located on a a 67 I couldn’t find it while looking
- 55Greg&Amy
- Posts: 1197
- Joined: Sun Nov 09, 2008 8:43 am
Re: 67 starts then dies as I let go of key
Not sure in a 67 but look for something like this. Usually near the ignition coil or on the firewall.
Greg Minnich
Kendallville, IN
Kendallville, IN
- Alan H. Tast
- Posts: 4253
- Joined: Wed Aug 20, 2003 10:52 pm
- Location: Omaha, NE
Re: 67 starts then dies as I let go of key
1960s-newer Ford products typically used a resistor wire inline between the ignition switch and the coil, and the '67 Tbirds are no exception. Usually this is a pink wire that's buried in the wiring harness. The wire heats up and builds resistance up to a set voltage point. This wire takes the place of a ceramic ignition resistor block pictured in this thread: Chrysler products typically used them.
I STRONGLY URGE you (or the person you're working on the car for) to get the factory shop manual and wiring/vacuum diagram manuals for your car. In fact, demand that the owner get you these manuals and tell him (or her) they'll save him (or her) more money than he (or she) will spend for your shop time to track this issue down. These will help you trace down potential problem points and provide repair directions.
I STRONGLY URGE you (or the person you're working on the car for) to get the factory shop manual and wiring/vacuum diagram manuals for your car. In fact, demand that the owner get you these manuals and tell him (or her) they'll save him (or her) more money than he (or she) will spend for your shop time to track this issue down. These will help you trace down potential problem points and provide repair directions.
Alan H. Tast, AIA
Technical Director/Past President,
Vintage Thunderbird Club Int'l.
Author, "Thunderbird 1955-1966" & "Thunderbird 50 Years"
1963 Hardtop & 1963 Sports Roadster
Technical Director/Past President,
Vintage Thunderbird Club Int'l.
Author, "Thunderbird 1955-1966" & "Thunderbird 50 Years"
1963 Hardtop & 1963 Sports Roadster
Re: 67 starts then dies as I let go of key
Please advise me as to where and how to order this. Thanks a million. Mike
-
- Posts: 1
- Joined: Sat Nov 04, 2023 7:54 am
Re: 67 starts then dies as I let go of key
Did you ever resolve this? I have to laugh at my scenario. I bought my 67 and drove it around that same weekend. Sunday morning of the first weekend i went to start it up and It was the same symptom you describe. I would turn the key and the engine would crank but as soon as i let go of the key it would shut off. IT did this for about 6 weeks of afternoon troubleshooting. Tried all the usual business. Just decided to go new on a lot of things. Carb replaced, plugs, wires, coil, fuel line from the tank to the engine (ethanol rated hose is expensive!) Anyway, I'm less informed on the mechanical side of things and that's one reason i bought my T bird. Plus, I have some help from other people i know. My good help buddies/family were overthinking it though. I asked early on if the ignition switch was the problem and they said no, your obviously getting spark. The car sat for 4 more weeks until I was at my wit's end and decided to remove the dash panels to see if anything obvious would show up. Sure enough, a crimped connection had come loose off the back of the ignition switch. I put it loosely back together and started the Tbird right up!
Goodluck to you if you havent already fixed your issue
Goodluck to you if you havent already fixed your issue