I purchased a nice clean SoCal seat and set of manual tracks. It appears they are from two different cars. I believe the lower seat frame may be from a power seat car. When I install the driver's side track the adjuster handle rests right against the metal apron. An online search for images shows there should be a slotted hole for this adjuster. My question, can I simply notch this area to accept the lever?
Thanks again, Greg
Seat Help?
Moderator: Joe Johnston
Re: Seat Help?
I'm pretty sure that would be the solution, just cut enough to fit into the frame. Just make sure that once you have it together that it is secure.
1956 Thunderbird Sage Green
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309
1953 Ford Custom Liner Hot Rod With Flat 8 Motor with Henderson three 2 barrel Carbs
VTCI Member # 12309