Page 1 of 1

HEADERS...

Posted: Sun Apr 22, 2018 8:38 pm
by gravelman
Does anyone know if these headers will work on our car. 428 Cobra jet exhaust manifolds Ford #C80Z-
9430-A (RH) and #C80Z-9431-A.(LH) I'm concerned about clearance?

Thanks,

Re: HEADERS...

Posted: Tue Apr 24, 2018 9:50 am
by Terry64HT
I have headers from Ford Powertrain and they are really tight, no more than 1/4" to the frame. I think all companies that make headers for our cars have to wrestle with the space limitations. I doubt that CobraJet ones would fit.
Terry
64HT

Re: HEADERS...

Posted: Tue Apr 24, 2018 10:53 am
by paulr
I tried searching the MOD section for a half hour and could not find it, but this has been talked about for sure by people who attempted multiple options, including modifications to the shock towers. Maybe it was a '61/63??

Re: HEADERS...

Posted: Tue Apr 24, 2018 11:59 am
by gravelman
paulr, I spent time as well searching 'exhaust headers' and finally gave up. Most of the posts were about leaking exhaust manifolds...

Re: HEADERS...

Posted: Sat Apr 28, 2018 8:25 pm
by stubbie

Re: HEADERS...

Posted: Sat Apr 28, 2018 10:44 pm
by gravelman
Hi Stubbie,

I just search out the same info earlier in the week. Stan Johnson is extremely knowledgeable and a good guy to boot. So I'm going with his headers.
Many thanks for your reply...

Take care