Vintage Thunderbird Club International

I am looking for that 30 second switch under the dash but have not been able to find it. Can anyone tell me where it is located under the dash?

Thank you Terry.

Can anyone tell the voltage to the power window switches, my concern is the drivers side window. Thank you.

64Zcode, Grounds are always suspect on these cars and I will once again check them. Rt.146 I have checked the fuses and they are good. Thanks to both of you for the suggestions.

I am always amazed at the workings of the Thunderbird. I have a 1966 Thunderbird Hardtop with AC (not connected) and somehow something always shows up as a problem. My Drivers side power window was not working for about a year, I thought I figured out the problem and the window worked for a week. Th...

Terry64HT I am already a life memder.

I finally have success with the drivers side front window. I have been struggling to get it to work for months now and I have taken it out so many times that I just maybe able to do it with my eyes closed. It started when I changed the gear because the old old one was broken. When I replaced that ge...

What I did on the second attempt was to get thermostat gasket sealer and applied it to the engine water inlet, put the gasket on, let it set for about an hour, then applied more sealer to the gasket where the thermostat would sit, then applied more sealer on the water inlet of the overflow tank wher...

The spring mechanism is very confusing to me. Some say there must be tension on it before the regulator is connected to the motor gear. I don't know if the hook on the gear should be on top of the detent that holds it tense or on the bottom of the detent. And how much preload tension should the spri...

Terry64HT, thanks for the response, I measured the 12 volts at the connector in the door and the voltage was the same at both the red and yellow wires.

I have 1966 hardtop. The drivers window won't go up or down. When I push the switch I hear the motor give a soft click and then nothing. I am getting 12 volts to the motor, I replaced the nylon or plastic gear, the motor spins both ways on the test stand with 12 volts used. Is there a way to tell if...

Thank you Cacockrum for the answer and swift response.

Do I need to remove the surge tank to remove the thermostat? I have a 1966 hardtop with a 390, 4 barrel ?

Alan Tast, I did a search for thermostat and ended up here so I posted here. thank you for your response, does that mean I need to remove the surge tank to get to the thermostat?

sseebart, does that mean I need to take off the overflow tank to get to it?