Vintage Thunderbird Club International

I cleaned out a shelf in my barn and found wiper arms, 2 sets of 61-63 and 2 unidentified sets, one set has a funky isolator on the blade mount both appear to be unpolished stainless steel. Posting to see if anyone can identify these.

HYDRO-E-LECTRIC Florida based.

Top relays C1SF-15672-A and 0SF-15672-D are now supplied with the bus bar tab boss shorter than the original. The swaging operation is ineffective in securing the tab to the boss as it can be lifted off with finger pressure. I called this to attention of the vendor and replacements were sent out but...

The 61 and 62 Thunderbird harnesses that I worked on only had resistance wire under the dash. Easy to splice in standard copper wire from ignition switch to the harness plug on the firewall. Top plug, top row, second wire in from the right. I don't know what the spec is on the thunderbird resistance...

61 only. 62-63 had idle control moved to inside under dash. Suggest you get reproduction of 62 Tbird Electrical Assembly Manual to see how system went together. Fast Idle Device 62 Electric Assembly Manual shown on page 64 or Sheet 11 of 11 Drawing Page E2-4720-11. Shown on carb, when it moved unde...

I stumbled across this illustration in one of the vendor catalogs I have, it shows the rag joint coupling for the non-swing away steering column. The coupling that came with my 61 was beat and I could not locate a similar one to fit the splined input shaft of the steering box. I swapped in a steerin...

Karl,
I replaced the bearing in my 61 a few months back and do not remember any spacers. Just remember the bearing was pricey and purchased from Amazon! Bearing was recently up on Rock Auto as a close-out deal. Sorry no photos!

I have a couple of cores, PM me if you are interested.

Do yourself a favor and solder a ground wire to the outside of the new sockets and run the wire to a good ground. I've done that to every new or old sockets on the rear and front turn signals on both my projects. No ground issues with the lights.

Fresh air inlet duct.png This is what you need to purchase, they were in stock a month ago at Pat Wilson Thunderbird parts and I purchased one. You will have to remove the rubber and clamp from the new part and reuse the original flange. [img][/img][attachment=0]PXL_20240109_165209935.jpg (Below) O...

Marketplace or Craigslist is where I would start, I looked on Car-Part.com and found a couple of salvage yards that wanted $900 for a core. I ended up driving 400 miles round trip for my replacement.

The part number for this connector is S2292 Standard Motor Products. Disclaimer on that part number, it appears the insulator has changed in the four years since I purchased this for my last build. I purchased two different brands and neither fit. The slot in the bottom of the insulator is too smal...

The part number for this connector is S2292 Standard Motor Products.

That plug is steel and painted the body color. Never had to purchase one so I can't say if they are reproduced but I guess not. Should be easy to find used.

https://www.amazon.com/VViViD-Grain-Black-Leather-Contact/dp/B01MR89OSP/ref=asc_df_B01MR89OSP/?tag=hyprod-20&linkCode=df0&hvadid=642098447983&hvpos=&hvnetw=g&hvrand=13023841642908604433&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=901020...